When host connection by shell job ends for on server, it creates 4 CI-s: Windows and three Interfaces. It does not create a link between the IP and Windows CI. And it doesnt create ntcmd ci. Thus it does not run host application by shell.
uCMDB was 10.01 - upraded it to 10.10 and the result was the same
server is windows 2012
It says the job was completed.
On a similar machine (windows 2012), it creates ntcmd CI-s and host application by shell runs ok.
Has anyone idea where to look for the mistake. I think the Data Flow Probe doesnt get the neccesary info from the server.
Do you also run Host Connection by WMI on the same nodes that are also discovered with Host Connection by Shell (NTCMD)
If you do, check the history on that node. I've seen Windows CIs that are discovered with both WMI and NTCMD, the other discovery job will delete the other protocol CI.
An example is that if you run Host Connection by WMI then it creates a related WMI agent to the node. Then run Host Connection by Shell, the job then removes the WMI agent and create the NTCMD agent. I've seen a few instances of this.