UCMDB and UD Practitioners Forum (Previously CMS)
cancel

Probe not showing in UI

SOLVED
Go to solution
Highlighted
chethan7845
Respected Contributor.

Probe not showing in UI

Hi 

I had installed QA uCMDB 10.22 and connected to Prod Copy of DB when i open my UI it was showing all Prod probe machines with disconnected status, My QA probe is not showing in UI can anyone knows what may be the issue.

 

Thanks

Chethan

 

1 REPLY
Rey_L
Honored Contributor.
Solution

Re: Probe not showing in UI

If you have a QA UCMDB 10.22 and connected to a copy of your Prod UCMDB 10.22 Database, your Prod Probes are still pointing to the Prod UCMDB 10.22

Unless you repoint them and change the UCMDB Server entry in the DataFlowProbe.properties file. Was this done?

If the Prod Probes are still connected to the Prod UCMDB  10.22 then a disconnect status is the expected status on your QA UCMDB 10.22

In your QA Probe, check the configuration in DataFlowProbe.properties to make sure its pointing to the QA UCMDB

If it is, any errors on the probe wrapper gateway log?

Rey Lejano

effectualsystems.com