UCMDB and UD Practitioners Forum (Previously CMS)
cancel
Showing results for 
Search instead for 
Did you mean: 

Does uCMDB keep track of WMI/PowerShell logon attempt to remote servers? I am running (uCMDB 10.11)

SOLVED
Go to solution
Highlighted
Leon_Cheyenne
Acclaimed Contributor

Does uCMDB keep track of WMI/PowerShell logon attempt to remote servers? I am running (uCMDB 10.11)

Does uCMDB keep track of WMI/PowerShell logon attempt to remote servers? I am running (uCMDB 10.11)

-thanks!

2 REPLIES
NikolaTodorov
Frequent Visitor
Solution

Re: Does uCMDB keep track of WMI/PowerShell logon attempt to remote servers? I am running (uCMDB 10

Hello Leon_Cheyenne,

All credentials should count the connection attempts to the targets. If a certain amount of attempts are reached (let say 5 or 10) the connection will fail and next WMI credentials should be taken for usage from the list.
Another point, if you stop, start and then rerun your WMI/PowerShell job, the stored successful credentials of the last discovery runs would be lost.

Best Regards,
Nikola

------------------------
Nikola Todorov
HPE Software Support

If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Leon_Cheyenne
Acclaimed Contributor

Re: Does uCMDB keep track of WMI/PowerShell logon attempt to remote servers? I am running (uCMDB 10

Thank you Nikola!

//Add this to "OnDomLoad" event