The community will be in read-only from Tuesday 11:59pm (PST) to Wednesday 7:30am (PST)
The community will be in read-only from Tuesday 11:59pm (PST) to Wednesday 7:30am (PST)
Storage Essentials Practitioners Forum
cancel
Showing results for 
Search instead for 
Did you mean: 

(SE) Support Tip: 3Par Remote Replication Information not captured by SE

Highlighted
DieterRohbeck
Regular Collector

(SE) Support Tip: 3Par Remote Replication Information not captured by SE

Hello SE/SOM Community,

if SE fails to capture Remote Replication information from 3Par Arrays you might have to adjust the 'replica_entity'  policy setting in the 3Par CIM configuration.

The default policy setting is "replica_entity", which makes SE or SOM fail to capture Remote Replication information. In order to get this information into SE/SOM you  will have to re-configure the CIM of the 3Par Array(s).

- connect to the 3Par cli (e.g. via SSH)
- run the command

setcim -pol no_replica_entity

-Stop the CIM on the 3Par with the command

stopcim

-Start the CIM on the 3Par with the command

startcim

-Wait for ~5 min and then run a GAED (Get All Element Details) in SE, or a Data Collection in SOM against the 3Par

The Remote Replication information should then be available in SE/SOM.

Note: These steps are mentioned in the SOM Userguide, but can't be found in the SE Documentation.

 

Best Regards,
Dieter

 

//Add this to "OnDomLoad" event