Service Desk Practitioners Forum
cancel

How to control values in Quick Find?

Highlighted
swapnil1
Contributor.

How to control values in Quick Find?

There are four fields in my HPSD4.5(sp22),namely
Assigned To Workgroup,Assigned To Person
and Problem Workgroup(custom field) & Problem Owner(custom field).

whenever i choose any workgroup,and click on the Quick Find button beside the Assigned To Person field, it shows the persons related to the chosen workgroup.It is possible as these
are the already given fields by HPSD,
but if want to the same thing with my two custom fields, how can i do it?
Is it possible? The values are shown in Quick Find, how can i set the filter there to show only required data?
Please reply.
2 REPLIES
George M. Meneg
Acclaimed Contributor.

Re: How to control values in Quick Find?

Hello,

You can do this by generic relation. Create a generic relation between field1 and field2 and enter each and every one relation between these two fields.

Then create a UI rule to limit field range by generic relations.

You have to give a good read to generic relations (included in the sd45_sp20_addendum_en.pdf that you can find in the doc\ folder where you extract the patch file (SP20 or later)).
menes fhtagn
George M. Meneg
Acclaimed Contributor.

Re: How to control values in Quick Find?

Hello again,

Also have a look at http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1123778

Though the request is different, the mechanism is the same.
menes fhtagn