Service Desk Practitioners Forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Checking display setting

Highlighted
Bhuvnesh
Frequent Visitor

Checking display setting

Hello,
I am installing HPSD 4.5 on Solaris 8, I am finding that after installation, the display of wizards (like dbconfwizard) is not proper.
Instructions in installation guides asks for verifying that display setting was correctely exported.
Can some one please tell me how to check display settings?

Thanks.
1 REPLY
Ramaprasad N
Esteemed Contributor

Re: Checking display setting

In K Shell, You can check the DISPLAY settings using the command,
# echo $DISPLAY

to set the display,

# export DISPLAY=:0.0
# echo $DISPLAY (to verify)

then start the DB config wizard.
//Add this to "OnDomLoad" event