Service Desk Practitioners Forum
cancel

Checking display setting

Highlighted
Bhuvnesh
Honored Contributor.

Checking display setting

Hello,
I am installing HPSD 4.5 on Solaris 8, I am finding that after installation, the display of wizards (like dbconfwizard) is not proper.
Instructions in installation guides asks for verifying that display setting was correctely exported.
Can some one please tell me how to check display settings?

Thanks.
1 REPLY
Ramaprasad N
Outstanding Contributor.

Re: Checking display setting

In K Shell, You can check the DISPLAY settings using the command,
# echo $DISPLAY

to set the display,

# export DISPLAY=:0.0
# echo $DISPLAY (to verify)

then start the DB config wizard.