Service Desk Practitioners Forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Binding HP Connect-IT with LDAP using SSL on port 636. Recieving "unable to connect".

Highlighted
Dessouky
Occasional Advisor

Binding HP Connect-IT with LDAP using SSL on port 636. Recieving "unable to connect".

Binding HP Connect-IT with LDAP using SSL on port 636. Recieving "unable to connect".
3 REPLIES
The Pike
Honored Contributor

Re: Binding HP Connect-IT with LDAP using SSL on port 636. Recieving "unable to connect".

Dessouky
Occasional Advisor

Re: Binding HP Connect-IT with LDAP using SSL on port 636. Recieving "unable to connect".

Dear Pike,

I might be a bit new to ITRC. Do you have any clue of the error appearing.

Best Regards,
The Pike
Honored Contributor

Re: Binding HP Connect-IT with LDAP using SSL on port 636. Recieving "unable to connect".

This is the OV Service Desk forum. You might want to post your question under OV Asset Management or better yet... *search* the forums, if you have not already done so. I just clicked a couple of times and saw some LDAP+SSL threads.

OV Asset Mgmt (Connect-It, AssetCenter, Etc.):
http://forums13.itrc.hp.com/service/forums/categoryhome.do?categoryId=682

Points for the guidance are welcome.
Here's how to assign points:
http://forums13.itrc.hp.com/service/forums/helptips.do?#33

Since you're new, take a few minutes to read the rest of the faq, too.

The Pike
//Add this to "OnDomLoad" event