Remote Lights-Out Mgmt (iLO 2, iLO, RILOE II) Forum
cancel
Showing results for 
Search instead for 
Did you mean: 

ILO/HPONCFG help please...

Highlighted
Tim Toohey
Acclaimed Contributor

ILO/HPONCFG help please...

One of our servers had it's system board replaced recently and the tech could not figure out how to configure ILO after replacement. I have HPONCFG installed and working on the target server, but I am unable to get a response from the ILO in a browser. All I have done is configure a static IP (it is now pingable) and add a user account.

Is there a way to reset the board to factory defaults? I haven't found a script that does this. Should the web page be enabled by default? Thank you for any help you can provide. I can post configs as well, if desired.
1 REPLY
Tim Toohey
Acclaimed Contributor

Re: ILO/HPONCFG help please...

I didn't look very hard. hponcfg /reset was what I was looking for...found it right away.
//Add this to "OnDomLoad" event