Remote Lights-Out Mgmt (iLO 2, iLO, RILOE II) Forum
cancel

Find out iLO version remotely

SOLVED
Go to solution
Highlighted
Sandndan
Trusted Contributor.

Find out iLO version remotely

Hey guys,

 

is there a possibilty to check out the iLO version remotly, e.g. by cmd / vb / ps ?

I found a xml to setup network setting (see attached file), but there is on line for sntp settings, which is only for iLO 3 and iLO 4.

We are using iLO 1 and iLO 2 , too.

We configure iLO for each server with a VB program. It overwrites the needed xml files with special data depending on the severlocation. Before it runs the xml files, it should figure out whether it is iLO 3+ or less.

 

The mod_network.xml we use to configure DNS server for iLO. Now we want to configure sntp server too. So i found this line in the xml file:

 

Spoiler
           <!--        Firmware support infomation for next 4 tags :      -->
            <!--            iLO 4 - All versions.                          -->
            <!--            iLO 3 - All versions.                          -->
            <!--            iLO 2 - None.                                  -->           
            <DHCP_SNTP_SETTINGS value="Yes"/>
            <SNTP_SERVER1 value="0.0.0.0"/>
            <SNTP_SERVER2 value="0.0.0.0"/>
            <TIMEZONE value="America/Anchorage"/>

 

I guess, If I use this for iLO 1 and iLO2, I will get an error, won't I?

Is this possible? Can I check the iLO version via script?

 

Thanks a lot

Danny Sandner

2 REPLIES
Oscar A. Perez
Outstanding Contributor.
Solution

Re: Find out iLO version remotely

You can scan your network using the following URL and parse the XML reply you'd get if you happen to find an iLO.

 

http://<IP-Address>/xmldata?item=all

 

 




__________________________________________________
I work for Hewlett Packard

If you feel this was helpful please click the KUDOS! thumb below!
Sandndan
Trusted Contributor.

Re: Find out iLO version remotely

Thanks. It works. I think that will be fine and I can use this.