Quality Center / ALM Practitioners Forum
cancel

Winrunner on Quality Center 10.0

Highlighted
Gary Shick
Regular Contributor.

Winrunner on Quality Center 10.0

I currently have Winrunner scripts on Quality Center 9.0. I will be migrating to Quality Center 10.0. Will the Winrunner still be compatible with Quality Center 10.0?
7 REPLIES
john scarpino
Acclaimed Contributor.

Re: Winrunner on Quality Center 10.0

Gary,

From a HP - Mercury point of view HP will end all WinRunner support by 1 January 2011.

I hope this helps,
John Scarpino
Gary Shick
Regular Contributor.

Re: Winrunner on Quality Center 10.0

So, will the scripts work in Quality Center 10.0 even though Mercury doesnt support Winrunner?
john scarpino
Acclaimed Contributor.

Re: Winrunner on Quality Center 10.0

I am sure a way exists and you might be able to but I am not sure if and how the connectivity between QC and WinRunner was updated. From HP they are not supporting this.

Anyone here tried QC 10.0 with WinRunner?
Eric Schumacher
Acclaimed Contributor.

Re: Winrunner on Quality Center 10.0

Yes, It's supported.
john scarpino
Acclaimed Contributor.

Re: Winrunner on Quality Center 10.0

Eric - thanks!
Gary Shick
Regular Contributor.

Re: Winrunner on Quality Center 10.0

Thank You very much Eric.

Would any of you happen to have an answer to my other question about QC 10? http://forums.itrc.hp.com/service/forums/questionanswer.do?threadId=1402086
Eric Schumacher
Acclaimed Contributor.

Re: Winrunner on Quality Center 10.0

Gary, its a slippery slope to use one thread to link to another. I can't comment. If you have a support account I recommend that you make your queries to HP support directly to ensure you have correct and official information.