Project and Portfolio Management Practitioners Forum
cancel

Positioning Two Drill Down Portlets

Highlighted
Emir Gocen
Trusted Contributor.

Positioning Two Drill Down Portlets

Hi,

Is there a way to resize the drill down portlets so that the second one is positioned below? Please see the document that I have attached.

Thanks in advance.

Emir Gocen
3 REPLIES
Sascha Mohr_1
Outstanding Contributor.

Re: Positioning Two Drill Down Portlets

Hi,
are these two portlets you are drilling to set to be wide by default? We have a drilldown with multiple portlets, each of them is set to be wide by default and they are all below each other.
Emir Gocen
Trusted Contributor.

Re: Positioning Two Drill Down Portlets

Hi Sascha,

One of them was set narrow. I changed it to wide. It did not work. Then I reconfigured the drilling process and it worked. Thanks for the response.

Kind regards.

Emir
Emir Gocen
Trusted Contributor.

Re: Positioning Two Drill Down Portlets

Hi Sascha,

One of them was set narrow. I changed it to wide. It did not work. Then I reconfigured the drilling process and it worked. Thanks for the response.

Kind regards.

Emir