Project and Portfolio Management Practitioners Forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Execution Step question

SOLVED
Go to solution
Highlighted
TurboMan
Member

Execution Step question

Hi,

 

I wonder if it is possible for execution steps not to be shonw in the Graphical View?

Just the Decision steps to be shown.

 

Thanks in advance

TM

3 REPLIES
Jim Esler
Honored Contributor

Re: Execution Step question

No.

Jason Nichols K
Honored Contributor
Solution

Re: Execution Step question

The graphical view is going to display what you see in the Workbench, execution steps and all.  But, you can stack the steps on top of each other so that you don't see them, i.e. place the execution step where the next decision step is to go with all appropriate transitions in place, then place the decision step on top of it.  From PPM's perspective, everything will run just fine, but from the user's perspective, you won't "see" the execution step.

TurboMan
Member

Re: Execution Step question

Thanks Jason,

 

Sounds like it works.

But, in your case, it would be harder to do the maintenance.

 I hope HP takes this post as an enhancement, if it is possible to implement.

Anyway, it was too good to be true.

 

Regards

TM

//Add this to "OnDomLoad" event