The community will be in read-only from Tuesday 11:59pm (PST) to Wednesday 7:30am (PST)
The community will be in read-only from Tuesday 11:59pm (PST) to Wednesday 7:30am (PST)
Project and Portfolio Management Practitioners Forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Cost roll up information - PPM 8

SOLVED
Go to solution
Highlighted
Daniel Galvez
Collector

Cost roll up information - PPM 8

Hi all,

Does somebody knows if the following parameters (of the server.conf file) were discontinued?

com.kintana.core.server.TASK_ACTUAL_ROLLUP_INTERVAL=5
com.kintana.core.server.PROJECT_PV_UPDATE_INTERVAL_MINUTES=5
com.kintana.core.server.PENDING_COST_EV_UPDATE_SERVICE_ENABLED=true
com.kintana.core.server.COST_ROLLUP_INTERVAL_MINUTES=5
com.kintana.core.server.COST_RATE_RULE_UPDATE_INTERVAL_MINUTES=5
com.kintana.core.server.PENDING_COST_EV_UPDATE_SERVICE_DELAY=5

I'll appreciate your comments.
Kind regards,
Daniel
4 REPLIES
MikeCF
Super Collector

Re: Cost roll up information - PPM 8

Hi Daniel,

these parameters are deleted in version 8. If you need further details you can take a look into the what's new document of version 8.

Regards
Michael
Daniel Galvez
Collector

Re: Cost roll up information - PPM 8

Hi Michael,

Thanks for the response. Michael you are right I forgot that detail, but in the what's new paper does not says something with a replacement for that commands. Do you have any idea in PPM 8 how can I change those values?
We need to change that interval.

Kind regards,
Daniel
MikeCF
Super Collector
Solution

Re: Cost roll up information - PPM 8

Hi Daniel,

in version 8 there is the new schedule audit page available (Open -> Administration -> Schedule Services).
There you will find the
- Task Actual Rollup Service
- Project Planned Value Update Service
- Pending Cost EV Update Service
- Cost Rollup Service
- Cost Rate Rule Update Service
- Pending EV Updates Table Cleanup Service

All of them can be rescheduled to mmet your requirements.

Regards,
Michael
Daniel Galvez
Collector

Re: Cost roll up information - PPM 8

Michael,

Thank you very much for the response, It was that I need.

Kind regards,
Daniel
//Add this to "OnDomLoad" event