Network Management / (OpenView-NNM) Practitioners Forum
cancel

how to put interface in unmanaged status in NNM 8.10?

Highlighted
hp4u
Outstanding Contributor.

how to put interface in unmanaged status in NNM 8.10?

Hi Experts,
Can anyone guide me how to put any interface for particular node in Unmanaged status?


Regards,
Dharmendra
Regards,
hp4u
7 REPLIES
Manpreetss
Valued Contributor.

Re: how to put interface in unmanaged status in NNM 8.10?

Hi Dharmnedra,

You can use a command line.....ovtopodix -G
hp4u
Outstanding Contributor.

Re: how to put interface in unmanaged status in NNM 8.10?

Hi,
Can you explain little bit?
I don't want any changes in node status.I want only that interface to be in Unmanaged status.

Regards,
Dharmendra
Regards,
hp4u
b0bby
Respected Contributor.

Re: how to put interface in unmanaged status in NNM 8.10?

Hi Dharmnedra,

yes you can do this by adding the Interface IP add in netmon.noDiscover, so that in next discovery NNM would Ignore this IP address from discoverying.

$OV_CONF/netmon.noDiscover

EXAMPLES
The following entry describes a single IP address:
10.2.112.86 # ISDN Interface(your notes to remember next time)

Thanks



Giirish
Honored Contributor.

Re: how to put interface in unmanaged status in NNM 8.10?

Hello,

Here basically inside network devices you will find many ip's. Might be your customer want unmanage the unwanted IP addresses. through SNMP walk utility find the IP address available on that node then, check the run the following command to Unmanage that only.
ovtopodix -G
hp4u
Outstanding Contributor.

Re: how to put interface in unmanaged status in NNM 8.10?

Is this command is available in windows NNM 8.10.It shows unrecogonized?

Regards,
Dharmendra
Regards,
hp4u
WW599651
Trusted Contributor.

Re: how to put interface in unmanaged status in NNM 8.10?

Hi

The ovtopofix -G will not work in NNMi series . You have to put the ip address of the nodes in netmon.noDiscover file under conf directory and restart netmon service.

asoloperto
Acclaimed Contributor.

Re: how to put interface in unmanaged status in NNM 8.10?

Hello,

please ignore all posts until now. There is no netmon on NNM 8.x or above. You have the following options:

 

1. In the NNMi Web UI:

Go to the inventory workspace and open the Custom Interfaces view. Filter the list to your interfaces which you want to set to unmanaged. Select the lines and use menu item Actions > Management Mode > Not managed.

 

2. From the command line

Use the command nnmmanagementmode.ovpl (see reference page)

 

3. Design an interface filter and use it to set the matching interfaces to not polled (Monitoring Configuration)

 

I would use option 3. As I am on 9.10 I am not pretty sure if the command exists in 8.x or if the action is present, but my general advice is to upgrade to 9.10.

 

HTH and kind regards

 

Alessandro