Network Management / (OpenView-NNM) Practitioners Forum
cancel

Openview & environment

Selim
New Member.

Openview & environment

How do i setup a Environment trap for openview to poll cisco routers this way if Temperature is a bove a certain temperature i will get an alarm.

Tnx
Selim
My mind is a terrible thing to waste!
4 REPLIES
Jose Ibarra
Respected Contributor.

Re: Openview & environment

I would recommend configuring an snmp data collection and threshold event for the mib which reports temperature. You could set a threshold alarm to trigger if the value exceeds an acceptable level.

You will need to load the mib definition for the cisco equipment you plan to monitor.
Jose Ibarra
Respected Contributor.

Re: Openview & environment

I would recommend configuring an snmp data collection and threshold event for the mib which reports temperature. You could set a threshold alarm to trigger if the value exceeds an acceptable level.

You will need to load the mib definition for the cisco equipment you plan to monitor.
Jose Ibarra
Respected Contributor.

Re: Openview & environment

I would recommend configuring an snmp data collection and threshold event for the mib which reports temperature. You could set a threshold alarm to trigger if the value exceeds an acceptable level.

You will need to load the mib definition for the cisco equipment you plan to monitor.
Highlighted
Jose Ibarra
Respected Contributor.

Re: Openview & environment

I would recommend configuring an snmp data collection and threshold event for the mib which reports temperature. You could set a threshold alarm to trigger if the value exceeds an acceptable level.

You will need to load the mib definition for the cisco equipment you plan to monitor.