The community will be in read-only from Tuesday 11:59pm (PST) to Wednesday 7:30am (PST)
The community will be in read-only from Tuesday 11:59pm (PST) to Wednesday 7:30am (PST)
Network Management / (OpenView-NNM) Practitioners Forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Openview & environment

Highlighted
Selim
Acclaimed Contributor

Openview & environment

How do i setup a Environment trap for openview to poll cisco routers this way if Temperature is a bove a certain temperature i will get an alarm.

Tnx
Selim
My mind is a terrible thing to waste!
4 REPLIES
Jose Ibarra
Super Collector

Re: Openview & environment

I would recommend configuring an snmp data collection and threshold event for the mib which reports temperature. You could set a threshold alarm to trigger if the value exceeds an acceptable level.

You will need to load the mib definition for the cisco equipment you plan to monitor.
Jose Ibarra
Super Collector

Re: Openview & environment

I would recommend configuring an snmp data collection and threshold event for the mib which reports temperature. You could set a threshold alarm to trigger if the value exceeds an acceptable level.

You will need to load the mib definition for the cisco equipment you plan to monitor.
Jose Ibarra
Super Collector

Re: Openview & environment

I would recommend configuring an snmp data collection and threshold event for the mib which reports temperature. You could set a threshold alarm to trigger if the value exceeds an acceptable level.

You will need to load the mib definition for the cisco equipment you plan to monitor.
Jose Ibarra
Super Collector

Re: Openview & environment

I would recommend configuring an snmp data collection and threshold event for the mib which reports temperature. You could set a threshold alarm to trigger if the value exceeds an acceptable level.

You will need to load the mib definition for the cisco equipment you plan to monitor.
//Add this to "OnDomLoad" event