I need to receive error log from HMC console to NNM. is it possible ? i have already setup NNM IP & community string in HMC console's Trap senders tab & checked Test trap. but i have not received any traps.
What version of NNMi are you using? Using a V9.22 system, I uploaded the
ibmConvergedPowerSystems.mib MIB after obtaining it from the url you specified and when I tried to load it, I received the following error:
Could not load [IBM-CPS-MIB] MIB Module(s) from file user-snmp-mibs/ibmConvergedPowerSystems.mib at 11:56:55 AM: Failed to load MIB modules from [/var/opt/OV/shared/nnm/user-snmp-mibs/ibmConvergedPowerSystems.mib]: Problems were reported during parsing, unable to load requested MIBs.
This is different than the V1/V2 message you report. Upon inspection of the MIB, I found the following section:
Checking loaded MIBS, I found that the RFC1215 MIB is actually "RFC-1215". After changing "FROM RFC1215" to "FROM RFC-1215", I was able to load the MIB without error. Once that completed, I loaded the traps:
#nnmincidentcfg.ovpl -loadTraps IBM-CPS-MIB
SNMP trap(s) from mib module loaded: IBM-CPS-MIB.
Number of traps: 1.
The following traps were added to incident configuration:
problemTrap - .184.108.40.206.220.127.116.11.201.0.3
Please try the above edit and see if that allows you to load the MIB then update this discussion to indicate whether it has worked or not. If not, please provide version details for NNMi and I will try to replicate your issue in the lab.
HP Support If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution, If you are satisfied with anyone’s response please remember to give them a KUDOS and show your appreciation.