Network Management / (OpenView-NNM) Practitioners Forum
cancel

Device Profile

Highlighted
Bitdog
Honored Contributor.

Device Profile

I have several Checkpoint appliances responding with OID 

SNMP OBJECT ID: .1.3.6.1.4.1.8072.3.2.10

 

in the Configuration "Device Profiles" for this profile

CheckPoint Generic        .1.3.6.1.4.1.2620               CheckPoint         CheckPoint         [Firewall]  Firewall

 

the description says "No Device Profile found for this device. The assigned SNMP OID is the top of a Net-SNMP subtree"

 

Do I need to add or customize a profile?

 

of the 4 nodes to each have different icons

 

 

“The world as we have created it is a process of our thinking. It cannot be changed without changing our thinking.”
― Albert Einstein
2 REPLIES
wrs_hp
Member

Re: Device Profile

Hello,
Changing or adding a new device profile does nothing more than change the symbol or force that it is a switch or a router. The key here is the sysObjectID returned by the remote snmp agent. If this remote snmp agent returned a Checkpoint sysObjectID, we would be fine in this case. However, on your linux system the net-snmp agent is running as you stated, so it will return it’s sysObjectID and the net-snmp device profile would be used.
If possible, I would recommend running a CheckPoint remote snmp agent instead of the netsnmp agent as this would solve the issue.

Hope this helps
HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Bitdog
Honored Contributor.

Re: Device Profile

Hello,

 

The device in question is a CheckPioint appliance.  If the respondong agent is to be changed won't that have to be done by the Vendor?

 

Thanks

“The world as we have created it is a process of our thinking. It cannot be changed without changing our thinking.”
― Albert Einstein
//Add this to "OnDomLoad" event