Data Protector pausing for 8 mins after copying 110 GB
When running a 3 TB backup of 16 file systems on an HP-UX 11.31 system, I noticed the following pattern.
Between 110 GB and 172 GB are streamed to tape, then the tape stops, I/O on the file systems being backed up goes to 0 for about 8 minutes. Then streaming begins again for another 110GB or so. This works out to roughly 8 minutes of streaming followed by 8 minutes of inactivity. I have watched this patter repeat through many iterations.
Other backups are starting and completing while this was running and the load on the machine has also varied greatly without impacting the cycle.
Network is not involved. The cell manager, media agent, and disk agent are all on the same server, which is running HP-UX 11.31 and DP 6.20.
Has anyone seen this before, or does anyone have any ideas as to the cause? This is doubling the time required for this large backup session.