Data Protector Practitioners Forum
cancel

Block size does not match this device - DP 7.01

SOLVED
Go to solution
Stefano Colombo
Super Contributor.

Block size does not match this device - DP 7.01

I'm configuring a copy job from Disk to LTO.

When running it I got the following message

 

Warning]

From: BMA-NET@srvbck.xxx.xx  "Drive0" Time: 14/06/2013 09:36:33

Block size of RMA-NET@srvbck.xxx.xxx (16Kb)

does not match this device (512Kb).

Blocks will be repackaged. Performance degradation may occur.

 

where should I configure the blocksize to match LTO's 512kb ?

thanks

Stefano

 

 

 

2 REPLIES
Ing. Bernd Rieg
Super Contributor.
Solution

Re: Block size does not match this device - DP 7.01

The Block size of your disk has to be set to 512k in your RAID configuration.

Highlighted
Stefano Colombo
Super Contributor.

Re: Block size does not match this device - DP 7.01

Right , thanks for the point

Stefano