Client Automation Standard Practitioners Forum
cancel

Using SUS with RPM

Highlighted
sia2003
Member

Using SUS with RPM

Hi there,
the question is about how to configure the RPM for use our local SUS server for gathering patches from it, not from microsoft site, because we already have them... And if it possible - what i must type in MSSecure field, for what this field?
6 REPLIES
Roy O Gatewood_
Honored Contributor

Re: Using SUS with RPM

I think you have to set microsoft_sus_url parameter in patch.cfg to point to your SUS store.
sia2003
Member

Re: Using SUS with RPM

Hello Roy,
but what about necessary options which is show in web page?
And can you give me the example of your settings to MS SUS ?
Roy O Gatewood_
Honored Contributor

Re: Using SUS with RPM

I have not done this but here's what I understand.
You would want to change the SUS data feed via the Patch Admin page to point to where your SUS data is located.
Good luck.
sia2003
Member

Re: Using SUS with RPM

Hi there Roy,
My problem is in wish to use the WSUS (SUS 2.0), not the SUS, for which, as i understand, the RPM is intended...
Because the WSUS not use the mssecure_1033.cab and aucatalog1.cab...

One advice was for me to wait for RPM 3.0, which will be for WSUS usage...
But may be you can say something new?
Roy O Gatewood_
Honored Contributor

Re: Using SUS with RPM

hello.
I did see that thread and really don't have any thing to add.
I think there may be an Early Adopter program but I'm not sure how you'd get on it.
Good luck
sia2003
Member

Re: Using SUS with RPM

Well, thank you Roy,
i'll be waiting for a RPM 3.0
//Add this to "OnDomLoad" event